He knows how to replace the starter motor of your car

He knows how to replace the starter motor of your car

Replace our car starter motor may not be easy task, but we can not deny the fact that it is important to know how you replace a starter on their own.

The materials and tools necessary to be a starter to replace a marker, a projector, a jack, wrench and a crescent wrench sets.

The first step on how to replace a starter is the preparation. We need access from the bottom of the car, which means that the car must be moved into the same outlet or machine capable ofjacked. We need to examine the blocks of gypsum, if any, and the brake when everything is ready before jacking up the vehicle. A word of advice when working under a car or any other type of vehicle is to be extremely careful not to electrical wires or other contacts who are not considered to touch or be touched.

The second step, how to replace a starter to find the starter to replace. We have to find them, because there are different positions, depending on the starterthe model of the automotive industry. Home can be found on the driver's side. Those who have not seen a starter before, most times, looks like a tube about six inches in diameter and eight inches long. It has air-type holes on one side, going all the way around the cylinder. It also provides an assembly line and some electrical connections. In the old Automotive, the starter motor is located above or within theThe engine compartment.

Third step is to remove the links. As already mentioned, there are three compounds, ie, the connector assembly and the two electrical connections. These must be removed, but must be marked to avoid confusion. When you remove the connection assembly, are the instruments to be used in key Crescent and ratchet. It should be noted that there are times when the compounds are difficult to remove. The difficulty is very dependent on the age ofCar. It should also be emphasized, that not much should be used to remove connections, because we can further damage the car and we could not go to the end.

The fourth step, how to replace a starter is the installation. The reason why we need to be checked the links in the third phase, because the starter is installed using the reverse process, as are the connections removed.

The fifth step, how to become a starter to replace the systemthe negative battery cable to the battery. The connection must be tightened later. We can now verify that all connections are properly done by starting the engine.

We must not forget that the new start-up an office base, which means that the starter can be brought into the old store have the means to get a refund.

follett symphony ice maker 20x20 tent ski helmet headphones